Now, new material to generate electricity from water vapour
- Delhi: Multi-vehicle pileup on NH-1 leaves at least five dead
- Siachen avalanche: Air pocket under 35 ft of snow kept Lance Naik Hanumanthappa alive
- Facts dispute claims by banks: write-off gallops, recovery crawls
- Upset allies Akali Dal and Shiv Sena let BJP know: Keep us in loop
- David Headley deposition adjourned for the day following technical glitch
Scientists have created a new polymer film that can generate electricity from water vapour to power micro- and nanoelectronic devices.
The new material developed by engineers at Massachusetts Institute of Technology changes its shape after absorbing tiny amounts of evaporated water, allowing it to repeatedly curl up and down.
Harnessing this continuous motion could drive robotic limbs or generate enough electricity to power micro- and nanoelectronic devices, such as environmental sensors.
"With a sensor powered by a battery, you have to replace it periodically. If you have this device, you can harvest energy from the environment so you don't have to replace it very often," said Mingming Ma, lead author of a paper describing the new material in the journal Science.
"We are very excited about this new material, and we expect as we achieve higher efficiency in converting mechanical energy into electricity, this material will find even broader applications," said Robert Langer, senior author of the paper.
The potential applications include large-scale, water-vapour-powered generators, or smaller generators to power wearable electronics.
The new film is made from an interlocking network of two different polymers. One of the polymers, polypyrrole, forms a hard but flexible matrix that provides structural support. The other polymer, polyol-borate, is a soft gel that swells when it absorbs water.
"By incorporating the two different kinds of polymers, you can generate a much bigger displacement, as well as a stronger force," co-author Liang Guo said.
The film harvests energy found in the water gradient between dry and water-rich environments. When the 20-micrometre-thick film lies on a surface that contains even a small amount of moisture, the bottom layer absorbs evaporated water, forcing the film to curl away from the surface.
Once the bottom of the film is exposed to air, it quickly releases the moisture, somersaults forward, and starts to curl up again. As this cycle is repeated, the continuous motion converts the chemical energy of the water gradient into mechanical energy.